TSB-05 Cam Guide Installation

TSB – 05 Metal Cam Guide Installation
Ver 1.0
2024 01 21

Summary

Installation of metal Cam Guides on the Lapera Group

Tools and parts required:

  • 5mm Hex Key
  • Phillips #1 Screwdriver
  • Dow 111 food-safe silicone grease
  • 2 x Cam Guides
  • 2 x Cam Guide Shims

⦿ Cam Guides

⦿ Cam Guide Shims

Step 1

⦿ Unscrew and remove lever

⦿ Remove 2 x M3 screws

⦿ Remove Group Cap

Step 2

⚠ Note – this process only works if your hammer is at least 100 years old.

Step 3

⦿ Apply a light coating of grease to the Cam Guides and Shims

Step 4

⦿ Place the Cam Guide Shims as shown

Step 5

⦿ Place the Cam Guides on top of the Shims as shown

Step 6

⦿ Install 4 x M6 screws finger tight

Step 7

⦿ Push the Cam Guides inwards so that they are flush with the Cam

⦿ Tighten the 4 x M6 screws enough to hold the Guides in place

Step 8

⦿ Tighten 4 x M6 screws firmly (Torque to 16Nm). Check the fit with the Cam during operation and readjust if necessary.